+61 (04) 3599 1950
enquiries@biostatengineering.com
  • Home
  • About us
  • Services
  • Products
  • FAQ
  • Distributors
  • Contact Us

Screen Clean Plus

July 27, 2016support
What is Screen Clean Plus
Guarantees extended submersible pump life and bore hole yield
What is Screen Clean Plus

When iron bacteria infects a bore, the resulting growth is usually deposited onto bore hole equipment. Iron oxide (due to bacteria) suspended in bore water is usually exhibited as bio-fouling in irrigation pipes. Growth deposits impact on bore hole equipment as well as irrigation plumbing.

Iron bacteria increases the problems associated with iron and sulphate reducing bacteria contribute to clogging, corrosion and bio-fouling of the bore hole. It causes unsightly staining on buildings, equipment, plants, foot paths and road verges.

Screen Clean Plus is a new formulation for use when removal
of rust, scale and mineral deposits from bore holes or wells is
required.

Chlorine is commonly used, but fails to dissolve entrenched iron bacteria fouling. Screen Clean Plus through its two part formulation acts on both organic and inorganic substances to give complete penetration into the encrustation. Additionally Screen Clean Plus sterilises the bore hole and gives immediate relief from iron bacterial problems.

The best time to clean up iron problems is as early as possible before any real damage is done. This should be long before any of the debilitating symptoms appear. If the problem is localised and caught in the early stages, chemicals can give a measure of control over a period of time.

Guarantees extended submersible pump life and bore hole yield

Screen Clean Plus is used successfully either by simply tipping it down the bore hole while the pump is still in position or for more complete remedial work the pump is removed and the bore hole treated.

Simple procedure – Disconnect the pump from the pipe work at the bore hole surface. Tip the mixed chemical down the bore hole and leave for 24 hours. After this time pump the bore hole water to waste until the water
is clear.

How much? How serious is the problem? In general there are two dilutions. >10% if the problem is serious or >5% for a general maintenance dose. Commonly in a 101mm bore , 1 litre of Screen Clean Plus per metre of bore hole water will give approximately a 10% solution.

Available globally through distributors & retailers in : 5 litre, 20 litre & 200 litre drums.

  • This field is for validation purposes and should be left unchanged.
DOWNLOAD BROCHURE

Our Products

  • Accu-San
  • BoreVac
  • ChloSan
  • CWPUV(Clean Water Plant) Series
  • Drinksafe-3
  • Drinksafe-8
  • DWP(Dirty Water Plants) Series
  • HaloVac
  • Flowell
  • LakeVac
  • PolyVac
  • Screen Clean Plus
  • TIRM DMI65
©2016 Biostat Engineering site by:  cyanweb